p p r r e e l l i i m m i i n n a a r r y y g g a a n n p p o o w w e e r r a a m m p p p p a a l l l l e e t t r r t t p p 0 0 9 9 0 0 5 5 0 0 - - 2 2 0 0 ? tel : 82-31-250-5078 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 1.0 product features application ? doherty amplifier design ? small and light weight ? 50 ohm input/output impedance matched ? highly reliable and rugged design ? high efficiency, high gain ? 52.5w typical p av g ? lte, gsm rrh description the RTP09050-20 is designed for rf system application frequencies from 925mhz to 960mhz, with high gain. this pallet amplifier uses gan on sic hemt techno logy which performs high breakdown voltage, high linearity, and high efficiency. the RTP09050-20 is a lte dpd application amplifier electrical specifications @ vdd= 45v, 50 ? system parameter symbol specification frequency range bw 925 ~ 960mhz operating bandwidth within bw obw 5 ~ 35mhz average output power pout 47.2dbm(52.5w) avg. @ lte 1fa 10mhz peak output power psat 54.2dbm (min.) @ duty 10% pulse aclr (lte 1fa 10mhz) @ po=+47.2dbm max. aclr pre-dpd -26dbc(min) @10mhz @-30 ~ +65 c 45v, cfr 6.5db post-dpd -53dbc(min) @10mhz gsm multi carrier imd (papr 7.5db) imd pre-dpd -25dbc(min) @15mhz @-30 ~ +65 c 45v, cfr 7.5db post-dpd -55dbc(min) @15mhz rf gain @ 25 g 55db (min.) gain flatness g 2.0 db(peak to peak) @ operating frequency input return loss s11 -12db (max.) output return loss s22 -17db (max.) normal operating voltage vdc +5.6v & +45v current consumption idd 0.2a @ 5.6v (max.) 3.0a @ 45v (typ.) efficiency eff 39% @ 45v (typ.) feedback output level @ 47.2dbm fb +9dbm 1.5db temp detector t 0.9v @ 40
p p r r e e l l i i m m i i n n a a r r y y g g a a n n p p o o w w e e r r a a m m p p p p a a l l l l e e t t r r t t p p 0 0 9 9 0 0 5 5 0 0 - - 2 2 0 0 ? tel : 82-31-250-5078 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 1.0 environmental characteristics parameter symbol min. typ. max. unit operating ambient temperature ta -30 +65 c storage temperature tstg -40 +130 c relative humidity w/o condensation rh 80 % maximum rating input overdrive p od -2dbm max. load vswr : 1 (all phase & amplitude) nom. operating case temperature tc +100 c interface connector 8-pin-control (molex_5267_08) pin # description specifications 1 vcc +5.6v 2 - 4 vcc +45v 5 - 8 gnd ground yeonho 4pin-control (smw200-04p) pin # description specifications 1 enable amp enable(+5.6v ) / amp disable(+0v) 2 - 3 gnd ground 4 temp det temp sense (0.9v @ 40 ) mechanical specifications parameter value units limits dimensions 170 100 18.8 mm weight 0.6(max) kg rf connectors (input, output, output coupling) sma(female) i/o connector smw200 4pin(male) molex 8pin(male) cooling external heat-sink
p p r r e e l l i i m m i i n n a a r r y y g g a a n n p p o o w w e e r r a a m m p p p p a a l l l l e e t t r r t t p p 0 0 9 9 0 0 5 5 0 0 - - 2 2 0 0 ? tel : 82-31-250-5078 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 1.0 outline drawing this device is susceptible to damage from e.s.d or e.m.i when the case is open caution input fb output +31v +31v +31v +5.6v gnd gnd gnd gnd 5 6 8 7 1 2 3 4 i/o 1 8 4 1 gnd gnd temp det enable 1 2 3 4 i/o flange (t=6.0) pcb (t=0.8) gasket (t=0.3) cover (t=11.7) (0,0) RTP09050-20 budget unit : mm *note : connector positions and module mount holes may be subjected change.
p p r r e e l l i i m m i i n n a a r r y y g g a a n n p p o o w w e e r r a a m m p p p p a a l l l l e e t t r r t t p p 0 0 9 9 0 0 5 5 0 0 - - 2 2 0 0 ? tel : 82-31-250-5078 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 1.0 test data (test results: dpd operation) test equipments - dpd engine : optichron op6180 board - signal generator : e4438c (agilent) - spectrum analyzer : e4440a (agilent) - network analyzer : 8753es (agilent) - power supply : 6674a (agilent) test condition - signal : lte 1fa 10mhz(papr 6.5db) & gsm 4fa(papr 7.5db) - cfr apply - amp temperature: 40 c input vswr (s11) & gain (s21) output vswr (s22) pre ? dpd @ 930mhz post- dpd @ 930mhz
p p r r e e l l i i m m i i n n a a r r y y g g a a n n p p o o w w e e r r a a m m p p p p a a l l l l e e t t r r t t p p 0 0 9 9 0 0 5 5 0 0 - - 2 2 0 0 ? tel : 82-31-250-5078 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 1.0 pre ? dpd @ 942.5mhz post- dpd @ 942.5mhz pre ? dpd @ 955mhz post- dpd @ 955mhz pulse duty 10% @ 930mhz pulse duty 10% @ 942.5mhz
p p r r e e l l i i m m i i n n a a r r y y g g a a n n p p o o w w e e r r a a m m p p p p a a l l l l e e t t r r t t p p 0 0 9 9 0 0 5 5 0 0 - - 2 2 0 0 ? tel : 82-31-250-5078 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 1.0 pulse duty 10% @ 955mhz gsm 4fa tone spacing 15mhz (fc = 942.5mhz ,papr 7.5db) gsm 4fa tone spacing 15mhz (fc = 942.5mhz,papr 7.5db)
p p r r e e l l i i m m i i n n a a r r y y g g a a n n p p o o w w e e r r a a m m p p p p a a l l l l e e t t r r t t p p 0 0 9 9 0 0 5 5 0 0 - - 2 2 0 0 ? tel : 82-31-250-5078 ? all specifications may change without notice. ? rfsales@rfhic.com ? version 1.0 test sheet s/n 0001 gain 55.2 db gain flatness 1.03 db s11(min) -13.1 db s22(min) -20.5 db feedback level@ 47.2dbm 9.5 dbm test frequency (@center) 930 mhz 942.5 mhz 955 mhz psat (dbm) 54.8 55.09 55.11 lte 10mhz @50w aclr@10mhz (dbc) pre-dpd -27.3 -26.5 -26.4 post-dpd -56.8 -56.1 -55.0 300ma/5.6v, current/45v a 2.91 2.9 2.92 efficiency % 40 40.2 39.9 gsm 4fa @ tone spacing 15mhz (papr 7.5db) worst spurious (dbc) pre-dpd -27.26 post-dpd -60.01 rfhic corporation (rfhic) reserves the right to make changes to any products herein or to discontinue any product at any time w ithout notice. rfhic do not assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, inclu ding without limitation consequential or incidental damages. the product specifications herein expressed have been carefully checked and are assumed to be reliable. how ever, rfhic disclaims liability for inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase or ders. rfhic products are not intended for use in life support equipment or application where ma lfunction of the product can be expected to result in persona l injury or death. buyer uses or sells such products for any such unintended or unauthorized applicatio n, buyer shall indemnify, protect and hold rfhic and its direct ors, officers, stockholders, employees, representatives and distributors harmless against any a nd all claims arising out of such use. rfhic?s liability unde r or arising out of damages, claims of whatsoever kind and nature which rfhic p roducts could cause shall be limited in amount to the net p urchase p rice of the p roducts sold to bu y er b y rfhic .
|
